USE AND OPERATIONThese valves are used when two equal cylinder, that are not mechanically coupled, supplied by the same pump and controlled by a single valve, must move simultaneously both in extension and retraction. MATERIALS AND FEATURESBody: zinc-plated steel.Internal parts: hardened and ground steel.Seals: BUNA N standard.Load holding: matched diameters, minimal leakage. Cylinder stroke error tolerance of ±3% of maximum flow. Any synchronisation errors are compensated for at the end of stroke.CONNECTIONSConnect P to supply flow and A and B to the cylinders.
USE AND OPERATIONThese valves are used when two equal cylinder, that are not mechanically coupled, supplied by the same pump and controlled by a single valve, must move simultaneously both in extension and retraction. MATERIALS AND FEATURESBody: zinc-plated steel.Internal parts: hardened and ground steel.Seals: BUNA N standard.Load holding: matched diameters, minimal leakage. Cylinder stroke error tolerance of ±3% of maximum flow. Any synchronisation errors are compensated for at the end of stroke.CONNECTIONSConnect P to supply flow and A and B to the cylinders.
USE AND OPERATIONThese valves are used when two equal cylinder, that are not mechanically coupled, supplied by the same pump and controlled by a single valve, must move simultaneously both in extension and retraction. MATERIALS AND FEATURESBody: zinc-plated steel.Internal parts: hardened and ground steel.Seals: BUNA N standard.Load holding: matched diameters, minimal leakage. Cylinder stroke error tolerance of ±3% of maximum flow. Any synchronisation errors are compensated for at the end of stroke.CONNECTIONSConnect P to supply flow and A and B to the cylinders.
USE AND OPERATIONThese valves are used when two equal cylinder, that are not mechanically coupled, supplied by the same pump and controlled by a single valve, must move simultaneously both in extension and retraction. MATERIALS AND FEATURESBody: zinc-plated steel.Internal parts: hardened and ground steel.Seals: BUNA N standard.Load holding: matched diameters, minimal leakage. Cylinder stroke error tolerance of ±3% of maximum flow. Any synchronisation errors are compensated for at the end of stroke.CONNECTIONSConnect P to supply flow and A and B to the cylinders.